DIY vs. Industrial Epoxy
Why 100% solids industrial epoxy outperforms water-based DIY kits in Orange County’s heat and UV environment -- the chemistry behind a lasting floor.
Read: DIY vs. Industrial Epoxy ›Orange County Epoxy Education
The Garage Pros OC
Knowledge Hub
Before you hire anyone to coat your garage floor, read this. We break down the science, the shortcuts to avoid, and why most coatings fail in Orange County’s climate.
Get a Free Quote
ArmorPoxy System Specialist | 100% Solids Guarantee
In-Depth Guides
What Every OC Homeowner Should Know
Three articles covering the most common questions about garage floor coatings -- written by specialists who install them every day.
Why Diamond Grinding Matters
Diamond grinding to CSP 3 is the only prep method that guarantees lasting adhesion. Learn why acid-wash shortcuts lead to delamination within 1–2 years.
Read: Why Diamond Grinding Matters ›
Preventing Hot-Tire Pickup
Hot-tire pickup is the #1 cause of coating failure in OC garages. Learn the physics behind it and how the ArmorClad system is engineered to prevent it.
Read: Preventing Hot-Tire Pickup ›Why We Publish This
An Educated Customer Gets a Better Floor
Most garage floor coating companies would rather you not know the difference between water-based epoxy and 100% solids, or why acid washing produces inconsistent adhesion. We think the opposite. When you understand the process, you make a better decision -- and you know exactly what you’re getting when you hire Garage Pros OC.
Every article in this hub is written by our ArmorPoxy System Specialists based on real-world experience coating floors across Irvine, Newport Beach, Anaheim, and Fullerton. No filler, no fluff -- just the information you need.
See Our Full 5-Step ProcessKey Things to Know Before You Buy
- Water-based kits contain 40–60% solids -- the rest evaporates and never becomes coating
- Acid washing leaves inconsistent surface profiles that cause delamination
- Hot tires can reach 150°F -- most DIY coatings have a heat deflection point far below that
- UV from coastal sunlight yellows non-aliphatic top coats within 12–18 months
- Moisture vapor in OC concrete slabs can blow off a coating if not tested first
What the ArmorClad System Solves
- 100% solids -- every gram of wet coat becomes hard film
- Diamond grinding to CSP 3 -- guaranteed mechanical adhesion
- Engineered hot-tire resistance -- tested to OC summer conditions
- Aliphatic polyaspartic top coat -- UV-stable for 15+ years
- Pre-install moisture vapor testing -- standard on every project
The Science Behind It
Industrial Materials, Residential Application
The ArmorClad system starts with the same 100% solids epoxy used in commercial warehouses and aircraft hangars -- then our network of ArmorPoxy System Specialists applies it to your garage with the same rigor.
